D-Link DWS-1008 Cli Reference Manual page 309

DWS-1008 CLI Reference Guide
key string
author-password
password
Defaults:
• auth-port - UDP port 1812
• acct-port - UDP port 1813
• timeout - 5 seconds
• retransmit - 3 (the total number of attempts, including the first attempt)
• deadtime - 0 (zero) minutes (The switch does not designate unresponsive RADIUS
servers as unavailable.)
• key - No key
• author-password - dlink
Access:
Usage: For a given RADIUS server, the first instance of this command must set both the
server name and the IP address and can include any or all of the other optional
parameters. Subsequent instances of this command can be used to set optional
parameters for a given RADIUS server.
To configure the server as a remote authenticator for the switch, you must add it to a server
group with the set server group command.
Do not use the same name for a RADIUS server and a RADIUS server group.
Examples:
command:
DWS-1008# set radius server RS42 address 198.162.1.1 timeout 30 retransmit 2
deadtime 5 key keys4U
D-Link Systems, Inc.
Password (shared secret key) the switch uses
to authenticate to the RADIUS server. You must
provide the same password that is defined on the
RADIUS server. The password can be 1 to 32
characters long, with no spaces or tabs.
Password used for authorization to a RADIUS
server for users seeking MAC or last-resort
network access. Specify a password of up to
32 alphanumeric characters with no spaces or
tabs.
Note: A change to the authorization password
applies both to MAC users and to last-resort
users.
Default values are listed below:
Enabled.
To set a RADIUS server named RS42 with IP address 198.162.1.1 to use the
default accounting and authorization ports with a timeout interval of 30
seconds, two transmit attempts, 5 minutes of dead time, a key string of
keys4u, and the default authorization password of dlink, type the following
RADIUS Commands
308