Show Fdb Agingtime; Show Fdb Count - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

show fdb agingtime

Displays the aging timeout period for forwarding database entries.
Syntax: show fdb agingtime [vlan vlan-id]
vlan vlan-id VLAN name or number. If you do not specify a VLAN, the aging timeout period
Defaults: None
Access: All
Examples: The following command displays the aging timeout period for all VLANs:
DWS-1008# show fdb agingtime
VLAN 2 aging time = 600 sec
VLAN 1 aging time = 300 sec
Because the forwarding database aging timeout period can be configured only on an individual
VLAN basis, the command lists the aging timeout period for each VLAN separately.

show fdb count

Lists the number of entries in the forwarding database.
Syntax: show fdb count {perm | static | dynamic} [vlan vlan-id]
perm
static
dynamic
vlan vlan-id VLAN name or number. Entries are listed for only the specified VLAN
Defaults: None.
Access: All.
Examples: The following command lists the number of dynamic entries that the forwarding
DWS-1008# show fdb count dynamic
Total Matching Entries = 2
D-Link Systems, Inc.
for each VLAN is displayed.
Lists the number of permanent entries. A permanent entry does not age out
and remains in the database even after a reboot, reset, or power cycle.
Lists the number of static entries. A static entry does not age out, but is removed
from the database after a reboot, reset, or power cycle.
Lists the number of dynamic entries. A dynamic entry is automatically removed
through aging or after a reboot, reset, or power cycle.
database contains:
VLAN Commands
52