Set Timedate - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
set system ip-address
Configures the system IP address. The system IP address determines the interface or source
IP address MSS uses for system tasks, including the following:
Syntax: set system ip-address ip-addr
ip-addr
Defaults: None
Access: Enabled.
Usage: You must use an address that is configured on one of the switch's VLANs. To display
the system IP address, use the show system command.
Examples: The following commands configure an IP interface on VLAN taupe and configure
DWS-1008# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
DWS-1008# set system ip-address 10.10.20.20
success: change accepted.

set timedate

Sets the time of day and date on the DWS-1008 switch.
Syntax: set timedate {date mmm dd yyyy [time hh:mm:ss]}
date mmm dd yyyy
time hh:mm:ss
Defaults: None
Access: Enabled
D-Link Systems, Inc.
• Topology reporting for dual-homed DWL-8220AP access points.
• Default source IP address used in unsolicited communications such as AAA
accounting reports and SNMP traps.
IP address, in dotted decimal notation. The address must be configured on one
of the DWS-1008 switch's VLANs.
the interface to be the system IP address:
System date:
• mmm - month.
• dd - day.
• yyyy - year.
System time, in hours, minutes, and seconds.
IP Services Commands
92