Ip Services Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use IP services commands to configure and manage IP interfaces, management services,
the Domain Name Service (DNS), Network Time Protocol (NTP), and aliases, and to ping a
host or trace a route. This chapter presents IP services commands alphabetically.
clear interface
Removes an IP interface.
Syntax: clear interface vlan-id ip
vlan-id
Defaults: None
Access: Enabled
Usage: If the interface you want to remove is configured as the system IP address, removing
the address can interfere with system tasks that use the system IP address, including
the following:
Examples: The following command removes the IP interface configured on VLAN mauve:
DWS-1008# clear interface mauve ip
success: cleared ip on vlan mauve
clear ip alias
Removes an alias, which is a string that represents an IP address.
Syntax: clear ip alias name
name Alias name.
Defaults: None
Access: Enabled
Examples: The following command removes the alias server1:
DWS-1008# clear ip alias server1
success: change accepted.
D-Link Systems, Inc.

IP Services Commands

VLAN name or number.
• Topology reporting for dual-homed DWL-8220AP access points
• Default source IP address used in unsolicited communications such as AAA
accounting reports and SNMP traps.
IP Services Commands
54