Pin Code Provisioning Settings Configuration; Viewing Configurations Configured Via Different Provisioning Methods - Yealink SIP-T5 Series Administrator's Manual

PIN Code Provisioning Settings Configuration

You can enable the users to trigger phones to perform provisioning by dialing a PIN code.
For more information on PIN code provisioning, refer to
The following table lists the parameters you can use to configure settings for PIN code provisioning.
Parameter phone_setting.retain_pin.enable
Description It enables or disables the phone to save the entered PIN code.
0-Disabled
Permitted
Values
1-Enabled, the phone saves the entered PIN code and users do not need to enter again.
Default 1
Supported
T57W, T54W, T53W, T53, T48U, T46U, T43U, T42U, T48S, T46S, T42S, T41S, T27G and CP920
Devices
Related
static.custom_mac_cfg.url
Parameters

Viewing Configurations Configured via Different Provisioning Methods

On the web user interface, you can click the question mark "?" after each configuration to see its detailed inform-
ation. It is only applicable to T57W/T54W/T53W/T53/T48U/T48S/T46U/T46S/T43U/T42S/T42U/T41S/T27G/CP920
phones.
From the detailed information, you can do the following:
Check whether settings you make using a higher priority provisioning method override settings made using a
l
lower priority provisioning method.
Reset a configuration to factory setting.
l
See the default value of the desired configuration.
l
The table lists each parameter in the detailed information.
Parameter
Description
CFG Configuration
Valid Value
Configuration Source Values
(This appears only when the para-
meter "static.auto_pro-
vision.custom.protect" is set to 1.)
Yealink SIP IP Phones Auto Provisioning
Description of this configuration item
The parameter in the configuration file
The permitted values
Not Applicable: the value is not changed via phone or
web user interface.
Web/Local:
(It appears only for a
Specific value: the value is changed via phone or web
non-static parameter.)
user interface. Click Reset to reset the value.
Not Applicable: the parameter is not changed in the con-
Config:
figuration files.
(It appears only for a
Specific value: the parameter is changed in the con-
non-static parameter.)
figuration files. Click Reset to reset the value.
Not Applicable: the parameter is not configured in any
provisioning method.
Static:
(It appears only for a
Specific value: the value is configured in any pro-
static parameter)
visioning method. Click Reset to reset the value.
Phone Provisioning
Guide.
<y0000000000xx>.cfg
Description
90