Pin Code Provisioning Settings Configuration; Viewing Configurations Configured Via Different Provisioning Methods - Yealink SIP-T2 Administrator's Manual

PIN Code Provisioning Settings Configuration

You can enable the users to trigger phones to perform provisioning by dialing a PIN code.
For more information on PIN code provisioning, refer to
The following table lists the parameters you can use to configure settings for PIN code provisioning.
Parameter phone_setting.retain_pin.enable
Description It enables or disables the phone to save the entered PIN code.
0-Disabled
Permitted
Values
1-Enabled, the phone saves the entered PIN code and users do not need to enter again.
Default 1
Supported T57W, T54W, T53W, T53, T48U, T46U, T43U, T42U, T48S, T46S, T42S, T41S, T33P, T33G, T31P,
Devices T31G, T31, T30P, T30, T27G and CP920

Viewing Configurations Configured via Different Provisioning Methods

On the web user interface, you can click the question mark "?" after each configuration to see its detailed inform-
ation. It is only applicable to T57W/T54W/T53W/T53/T48U/T48S/T46U/T46S/T43U/T42S/T42U/T41S/T27G/CP920
phones.
From the detailed information, you can do the following:
Check whether settings you make using a higher priority provisioning method override settings made using a
l
lower priority provisioning method.
Reset a configuration to factory setting.
l
See the default value of the desired configuration.
l
The table lists each parameter in the detailed information.
Parameter
Description
CFG Configuration
Valid Value
Configuration Source Values
(This appears only when the para-
meter "static.auto_pro-
vision.custom.protect" is set to 1.)
Yealink SIP IP Phones Auto Provisioning
Description of this configuration item
The parameter in the configuration file
The permitted values
Not Applicable: the value is not changed via phone or
web user interface.
Web/Local:
(It appears only for a
Specific value: the value is changed via phone or web
non-static parameter.)
user interface. Click Reset to reset the value.
Not Applicable: the parameter is not changed in the con-
Config:
figuration files.
(It appears only for a
Specific value: the parameter is changed in the con-
non-static parameter.)
figuration files. Click Reset to reset the value.
Not Applicable: the parameter is not configured in any
Static: provisioning method.
(It appears only for a
Specific value: the value is configured in any pro-
static parameter)
visioning method. Click Reset to reset the value.
Phone Provisioning
Guide.
<y0000000000xx>.cfg
Description
90