i-PRO WJ-NX510K Series Operating Instructions Manual page 67

[Setup via recorder's main monitor]
[Schedule recording]
Mark the checkbox (es) if you want to carry out the schedule recording based on the set
time bar.
[Event recording]
Mark the checkbox (es) if you want to carry out event recording based on the set time bar.
The recorder does not record the image even if the alarm occurs during time in which the
event recording is not set.
[e-Mail]
To send an alarm e-mail when an event occurs, mark this item. The event recording must be
checked to set this item.
Refer to the following section for the setting of the destination.
Configure the settings relating to the mail notification [e-Mail]
☞
[Alarm notification]
Mark the checkbox of this item to automatically transmit information on an event that
occurs to a PC using the TCP alarm notification protocol or HTTP. The event recording must
be checked to set this item. Refer to the following section for the setting of the address.
Configure the TCP alarm notification settings [TCP alarm notification]
☞
Configure HTTP alarm notification settings [HTTP alarm]
☞
Note:
● At the default, schedule recording and event recording have been set for
24 hours on Time table1. To delete the designated start and end time,
right-click the timetable.
● The recording time table can be set by dragging the start and end time on
the time bar with the mouse.
● Be sure to set so that there is no overlap between the 6 time tables. When
attempting to set the same time as already set on another time bar, the
time immediately before or after the overlapping time will be set.
● Within the same time table, event recording has priority over schedule
recording.
63