i-PRO WJ-NX510K Series Operating Instructions Manual page 268

[Operation via recorder's main monitor]
[AUX] button
Sets the device connected to the AUX terminal of the camera to the open/closed state.
If the camera is a network camera, AUX1, 2 and 3 is controlled with only AUX1 of the
camera.
If the device is the encoder GXE500, the AUX1 and 2 control terminals of a camera or a
receiver (WV-RC150) are applicable for each analogue camera
connected to it.
The AUX3 controls the AUX output terminal (1 system only) of GXE500.
[Wiper] button
Operates the washer/wiper of the WV-SUD638.
● Active ClearSight button
Operate the Active ClearSight.
[Setup] button
Displays the camera setup window for registering a home position, executing auto back
focus, etc.
Camera control panel
☞
264