Others
[Manually execute the failover]
Select a recorder No. and click the [Execute] button to switch the recorder. If the registered
information of the master recorder is changed, it is necessary to save the settings and click
the [Execute] button.
Configure the settings of the monitoring target recorder
Set master recorders subject to monitoring.
Click the [OK] button at the end to complete the change of registered information.
Note:
● When the status indicates Not available, check the version and the number
of licenses of the recorder and match them.
● The [Update] button can be clicked only when the failover operation is set
to On.
Important:
● Monitoring target master recorders are recorders with the same model
number.
● The recorder whose HDD operation mode (single/Mirroring/RAID5/RAID6)
is different from the slave recorder's HDD operation mode can not be set
as the master recorder for monitoring.
● The camera group recording operates according to the camera group
recording setting set in the slave recorder. The camera group recording
setting of the master recorder is not inherited.
393