i-PRO WJ-NX510K Series Operating Instructions Manual page 23

[Setup via recorder's main monitor]
[No.]
Shows a number of detected cameras. The maximum number of detectable cameras will be
192 units.
[Select]
Mark the checkboxes of cameras to register. The vacant number will be fulfilled by the
subsequent camera.
[Model]
If you are using a camera manufactured by us or Panasonic that is supported by this
camera, the part number of the camera will be displayed. Refer to our support website for
the supported cameras.
[Results]
New: Displayed when the camera is newly connected to the recorder.
Replaced: Displayed when the camera has been replaced by another one.
Added: Displayed when the camera connection is added to the recorder.
Registered: Displayed when the camera has already been registered.
Lost: Displayed when the registered camera is not detected.
Blank: No camera is detected.
[IP address]
Displays the IP addresses configured for the detected cameras.
[Auto addressing]
The IP addresses of the cameras whose checkboxes are marked will be automatically
configured.
[Start IP address]
Specify the start IP address and order when setting the IP address automatically.
Note:
● It is impossible to register cameras in other networks via the same router.
● For the security enhancement, changing of the IP address of the camera
will become impossible when 20 minutes have passed after the power is
turned on. Refer to the operating instructions of the camera for further
information.
● When "On" is selected for the "DHCP" setting of the detected cameras, the
19
" "