i-PRO WJ-NX510K Series Operating Instructions Manual page 276

[Operation via recorder's main monitor]
×: takes no action
*2 When "On" is selected for the "Additional alarm data" setting of the camera, i-VMD type
information will be displayed in the alarm log. For further information, refer to the
operating instructions of the camera in use.
*3 The extension software alarm is displayed by name. Alarms notified by message IDs that
are not set are displayed as "Undefined"
Set up recording/events [REC & event]
☞
*4 The extension software alarm notified by message IDs that are not set is recorded as
camera site alarm.
Set up recording/events [REC & event]
☞
Stop buzzer beeping
The buzzer sounding to announce an alarm or error can be stopped from the recorder's
front panel.
Step 1
Press the [BUZZER STOP] button.
→ The buzzer will stop.
Cancel the alarm action
The recorder will take an alarm action according to the settings configured in advance
when an event occurs in the alarm mode (ALM). Information of the occurred alarm will be
displayed on the status display panel of the main monitor. To reset the alarm action, click
the [Alarm] button on the status display panel, and click the alarm [Reset] button.
Main monitor (A monitor to display the live image, the playback image and the setup
☞
menu)
When an item other than "Ext." is selected for "Auto reset time" on the "Event setup" tab
under "REC & event" on the setup menu [Basic setup], the following actions will automatically
be taken even if the alarm action is not canceled by clicking the alarm [Reset] button.
Set up event [Event setup]
☞
Note:
● The buzzer can also be stopped by canceling the alarm action or error
action. The [BUZZER STOP] button does not reset any of the other alarm
actions.
Cancel the alarm action
☞
272