i-PRO WJ-NX510K Series Operating Instructions Manual page 401

Others
Symptom Cause/solution
● Check if the user name and password has correctly been
The message ● After the external storage device is inserted, it may take time
"Please insert a
medium." is
displayed even after
an external storage
device is inserted.
Cannot access from ● Is the Ethernet cable firmly connected to the 10BASE-T,
the web browser.
● Is the connection indicator of the network port lit on the rear
● Is the valid IP address set?
● Is the DHCP server connected to the network environment?
● Are you accessing the wrong IP address?
entered on the setup menu - the "Advanced setup" menu -
the [Camera] page - [Camera registration] tab.
to recognize the medium. Close the message window and
wait for a while before retry.
100BASE-TX, or 1000BASE-T port on the rear side?
Confirm the cable is firmly connected.
side?
When it is not lit, connection to a LAN is not established or a
network is not working correctly.
Confirm that the connection indicator of the network port is
lit. Refer to the system administrator if it is not lit.
Refer to a system administrator for further information about
the settings.
The default setting for the connection mode of the product is
"Fixed IP". If the setting is changed to "Auto (DHCP)", access
the device using the IP address obtained from the DHCP
server. The acquired IP address can be found in the
[Maintenance] - [System information] tab.
Check the connection by using a ping command from the PC
397
Reference
Change the
☞
registered
information
[Registered
information]
−
Installation Guide
Installation Guide
☞ Configure
the basic
network settings
[Basic]
Configure
☞
the basic
network settings
[Basic]
-