i-PRO WJ-NX510K Series Operating Instructions Manual page 149

[Setup via recorder's main monitor]
Configure the settings and operations relating to the system [System
management]
The settings relating to the actions at an error occurrence and auto data deletion from hard
disk drives can be configured on this tab. It is also possible to display the logs on this page.
In addition, general maintenance, such as license registration, setting initialization and
firmware upgrade, can be performed on this tab.
[NX310]
■ System setup
[Error output duration]
Select the duration to output a signal to notify the external devices of an error (HDD error,
camera error, recorder error, recording error or network error).
When "0 s" is selected, the signal is not output.
0 s/ 2 s/ 5 s/ 10 s/ 20 s/ 30 s/ 1 min
Ext.: When "Ext." is selected, the signal will keep on being output until the error is reset.
Default: 2 s
Important:
● HDDs in recording cannot be selected. If the HDD stand-by control mode
is On, a HDD following the HDD in recording also cannot be selected. If the
operation mode of HDDs is the mirroring mode, one of the two HDDs in
recording may be removed.
● After starting to format the HDD, copying, downloading and backing up to
NAS in process will stop.
[NX410/NX510]
145