i-PRO WJ-NX510K Series Operating Instructions Manual page 59

[Setup via recorder's main monitor]
a change (movement) is detected in the image. Refer to the
operating instructions of the camera in use for how to configure the VMD alarm.
On: Detects alarms.
Off: Does not detect alarms.
[Detection sensitivity]
To transmit the settings to the camera, mark this item, and select either of the following.
1(Low) - 15(High)
■ Camera Selection
Select the camera to which the setting of the "VMD alarm" is to be sent. Mark the checkbox
of the camera to which the setup information is to be transmitted.
[Transmission] button
Transmit the setting of the "VMD alarm" to the camera.
Once transmission is completed and the setting has been applied to the camera, "OK" will
be displayed in the "Results" field. If the display reads "Authentication error", etc., the
camera connection or the setting may have failed.
[Back] button
Click the button after completing the settings.
The screen returns to the [Camera setup] tab.
Set up VMD alarm for individual cameras [VMD alarm (Advanced
individual camera setup)]
Select the motion detection area and detection sensitivity for each camera and transmit the
information to the cameras to change the camera settings.
Clicking the "Advanced individual camera setup" [Setup >] button for "VMD alarm" on the
[Camera setup] tab will display the setup page.
Note:
● This menu collects setting information from the selected camera and
applies it on the setting screen.
● Only the fisheye network camera can set the "Fisheye" mode.
● The live image of the sub-monitor may not be displayed temporarily
depending on the setting of the image capture size of the recorded video.
55