i-PRO WJ-NX510K Series Operating Instructions Manual page 150

[Setup via recorder's main monitor]
[Error buzzer duration]
Configure the settings to sound a buzzer at an error occurrence. When "0 s" is selected,
buzzer will not sound.
0 s/ 2 s/ 5 s/ 10 s/ 20 s/ 30 s/ 1 min
Ext.: When "Ext." is selected, the buzzer that started sounding at an error occurrence will
keep on sounding until the buzzer is stopped.
Default: 2 s
[Safe shutdown time][NX410/NX510]
Set time to start the power outage process after the power failure detection signal is input
to the recorder.
10 s/ 20 s/ 30 s/ 1 min/ 2 min/ 3 min/ 4 min/ 5 min
Default: 10 s
[HDD stand-by control mode]
Set a mode not to count the operation time of a hard disk drive (HDD stand-by control
mode) by temporarily pausing HDDs other than those which are recording or waiting for
recording.
On：Operates in the HDD stand-by control mode.
Off：Operates in the normal mode.
Default: Off
Note:
● Refer to the following section for how to reset the error.
Cancel the error action
☞
Note:
● Refer to the following section for further information about how to stop
buzzer beeping.
Stop buzzer beeping
☞
Note:
● In Single mode, it is effective when it consists of 3 or more HDD.
● In Mirroring (RAID1) mode, it is effective when it consists of 6 or more
HDD.
● In RAID5/RAID6 mode, it is effective when it consists of 3 units or more.
146