i-PRO WJ-NX510K Series Operating Instructions Manual page 407

Others
Symptom Cause/solution
The thumbnail ● Check that the JPEG data encryption is not set to "On" in the
image of the
camera is displayed
broken in the setup
menu of the web
browser.
Camera settings do ● [Camera] - [The functions of this product will not change the
not match the
monitoring system
settings. The live
image on the
monitor is not
displayed correctly.
The camera does
not notify alarms.
PoE power supply ● If the PoE power supply to the camera exceeds the power
stopped.
When the camera ● When the load on this product exceeds the allowable
images can not be
displayed on the
HDMI monitor or
played back in the
browser, it will
restore after a while.
Front LCD display ● Due to the process of refreshing the LCD display, the
disappears for a few
seconds.
[NX410/NX510]
camera setup menu.
camera settings automatically] in [Advanced setup] is not
checked. When this setting is checked, no camera settings are
made. This may cause each function of the monitoring system
to fail to operate properly.
supply capacity of the IF1-WF01, the IF1-WF01 will stop PoE
power supply. Reduce the number of cameras connected to
the PoE power supply, and then click on the Error Resume
button.
Note that the PoE total power supply warning occurs when
80% of the power supply capacity is exceeded.
capacity, to continue the recording operation of this product,
the monitor display function is reset. At this time, it can not
be operated temporarily and will return to the start monitor
display in about 2 minutes.
characters on the LCD may disappear for a few seconds once
a day.
403
Reference
−
☞ Set up
advanced
[Advanced setup]
−
−
－