i-PRO WJ-NX510K Series Operating Instructions Manual page 144

[Setup via recorder's main monitor]
[Operation mode of HDD]
Operation mode of HDD will be displayed.
Refer to the following section for further information.
☞ About the setup of HDD operation mode
[Capacity]
Displays the capacities of the hard disk drives.
[Operation]
Displays the operating time of the hard disk drives.
[Status]
Displays the statuses of the hard disk drives.
Normal: Hard disk drives that are operating normally. The number indicates the order of
use.
Playback-only: Hard disk drives for playback use only (Recording is unavailable.)
Removed: Hard disk drives that are excluded from operation due to fault
Error: Hard disk drives that have become faulty during the format process
Blank: No HDD connected
Added: HDD cannot be used until it is formatted
[Recorded time range]
Displays the time range of the images recorded on the hard disk drives.
[Overwrite cycle]
Calculates and indicates the overwriting cycle of the hard disk drives, based on the past
recording performance (the date & time of the oldest recorded data, the current date &
time and the capacity of the hard disk drive).
Note:
● [NX310] Although the range of date and time are displayed for the
recovery target HDD even during mirroring recovery, the content will not be
the same as the recovery source HDD until the recovery is completed.
● [NX410/NX510] When using in Mirroring mode/RAID5 mode/RAID6 mode,
"Operation time" will be displayed for each hard disk drive respectively,
while "Capacity"/"Status"/"Recorded time range" will be displayed together
for multiple hard disk drives.
140