i-PRO WJ-NX510K Series Operating Instructions Manual page 103

[Setup via recorder's main monitor]
Off: Does not display the camera title
Default: On
■ Display settings
Set the display sequence for camera images (image switching).
[Mode]
Select how to display images from the cameras.
1-screen live sequence: Images from the cameras will sequentially be switched and
4-screen live sequence: Switch between 4 screens.
9-screen live sequence: Switch between 9 screens.
Switch by alarm terminal input: [NX310]The display camera is switched to Cam.1 to 9
24Screen: Images from the cameras will be displayed on 24Screen without switching the
32Screen: 32 screens are fixed and displayed.
[Keep aspect ratio]
Select whether to change the aspect ratio of the displayed area if the aspect ratio of the
image is different from the displayed area.
Checked: Keep aspect ratio (Does not change the ratio automatically)
Not checked: Does not keep aspect ratio (Changes the ratio automatically)
Default: Not checked
[Duration]
Set the interval (duration) for switching camera images.
3 s/ 5 s/ 10 s
Default: 5 s
displayed on 1-screen.
respectively according to the input signal of terminal alarm
terminal numbers 1 to 9 and displayed on a single screen.
When "Alarm input" is set in the General purpose I/O
terminal setting, General purpose I/O1 to 4 are switched to
camera 10 to 13 respectively.
[NX410/NX510]The display camera is switched to Cam.1 to
32 respectively according to the input signal of terminal
alarm terminal numbers 1 to 32 and displayed on a single
screen.
screen.
99