i-PRO WJ-NX510K Series Operating Instructions Manual page 123

[Setup via recorder's main monitor]
[Primary server address]
[Secondary server address]
Enter the address or name of the NTP server when adjusting the time using the NTP server.
The name of the NTP server is available only when "Manual" is selected for "DNS" on the
[Basic] tab accessed from the "Advanced setup" menu - the
"Network" page of the setup menu.
Enter up to 255 alphanumeric characters including hyphens (-) and periods (.).
■ SNMP setup
Set this item to check the status of the recorder by connecting to the SNMP server.
[SNMP version]
Select the SNMP version to be used.
By using SNMPv3, communication data can be encrypted and communication security can
be improved.
Off: SNMP is not used.
SNMMPv1/v2: SNMPv1/v2 will be enabled.
SNMPv3: SNMPv3 will be enabled.
SNMPv1/v2/v3: SNMPv1/v2/v3 will be enabled.
Default: Off
[SNMPv1/v2 - Community]
Enter a name used for SNMP authentication (up to 32 alphanumeric characters).
Characters that cannot be input: half-width symbols " " "
[SNMPv1/v2 - Prohibit access from the outside of subnet]
Set whether to prohibit access from the outside of subnet by SNMPv1/v2.
Note:
● Entering "http://" is not necessary if the server name is entered.
Important:
● It is possible to run the recorder as an NTP server to be referred by the
cameras. In this case, set the port number of the camera to "123". Refer to
the operating instructions of the connected camera for information on
how to configure the settings of the camera.
119