i-PRO WJ-NX510K Series Operating Instructions Manual page 156

[Setup via recorder's main monitor]
The setting values for the past three days are stored as of 2:10 a.m. every day. If the setting
has not been changed from the most recent setting at that time, it will not be saved.
Select the date and time of the settings you wish to restore, then click the [Execute >]
button to do so from the confirmation screen that appears.
[Firmware update]
Loads the software saved on a USB medium (external storage device) into the recorder to
upgrade the firmware. Click the [Execute >] button to display the confirmation window to
start initializing.
Only an administrator can execute the firmware update.
[Other]
The [Execute functions for special maintenance] screen appears.
Configure the settings and operations relating to the system [System management]
☞
[Reset all settings]
Initializes the setting data. Click the [Execute >] button to display the confirmation window
for starting initialization.
Important:
● After restoring the settings, be sure to click the [Set] button and exit the
menu.
Note:
● [NX410/NX510] Depending on the firmware to be updated, it may take up
to 30 minutes for upgrading, leaving the start screen displayed.
● Do not turn off the power of the device during the update.
● Usage time varies depending on the capacity of the USB medium or the
recording content. Retry again later if you fail in operation.
● Do not operate the recorder with multiple USB medium connected.
● Use the USB medium formatted in exFAT, FAT (FAT 16) or FAT 32.
● USB medium recognized by this recorder can be formatted by the
recorder. Refer to the following section for the format procedures.
Format USB medium
☞
● USB medium with password authentication or requiring a dedicated driver
or with the encryption function are not available.
● Contact your dealer for further information about the firmware update.
152