Connecting To The Ethernet Port - Xante Accel-a-Graphix CT4 User Manual

Connecting to the Ethernet Port

An external transceiver is required to connect your controller to the
network. The transceiver must have a medium attachment unit
interface (MAUI) to connect to the controller and a female connector
for the type of cabling used on your network. The following sections
describe the methods for connecting your printer to a network, using
two common types of network cabling; unshielded twisted pair (UTP
or 10BaseT), and thin coaxial cable (thinnet or 10Base2). Examples
of transceivers for both types of cabling are illustrated in figure 2.19.
MAUI Connector
(To Controller)
(Back View)
Fig. 2.19 Ethernet Transceivers and Cables
Note: In an EtherTalk network, your printer uses the AppleTalk
Phase 2 driver. Select the Phase 2 driver on a Macintosh
using the Network Control Panel or the AppleTalk Control
Panel (System 7.5 and up).
2-24 Installationbb _________________________________________
10BaseT
Transceiver
Unshielded
Twisted Pair
RJ-45
10Base2
Transceiver
Thin Coaxial
Cable Connection