Table of Contents
Advertisement
Configuring AutoCAD 12
After you install AutoCAD release 12, configure the program to print
to the controller using the following procedure.
1.
Select Configure from the File menu. A Configure menu
appears.
2.
Select Configure plotter. The Plotter Configuration menu
appears.
3.
Select Add a plotter configuration. The Available Plotters
screen appears.
4.
Select Postscript Device ADI 4.2 - by AutoDesk, Inc.
5.
Under Supported Models, select 300 dpi. The question "Do
you want color?" appears.
6.
Select Yes to answer the question. Then, the question, "Do you
wish to append a ^Z?" appears.
7.
Select NO. The question "Is your PostScript device connected
to a <S>erial or <P>arallel port?" appears.
8.
Select the port the controller is connected to, serial or parallel.
9.
Enter the address of the port you selected or press the Enter
key if there is no change.
10.
Check over your device location, and if you are satisfied, press
the Enter key for no changes. The question "Do you want to
change anything?" appears.
11.
Check over the list for all the selections. If you want to make
changes, type YES and press the Enter key; then make the
desired changes. If not, type NO, press the Enter key. The
message "Enter a description for the plotter:" appears.
12.
Enter the name you would like for the printer to have (such as
Sales).
____________________________________
Application Notes A-9
Advertisement
Table of Contents
Troubleshooting
