The Automatic Reduction Menu
The Automatic Reduction menu, PRINT:AUTOREDUCE, allows
you to choose whether to have oversized jobs automatically reduced
by the controller to fit the available print media. Oversized jobs are
cropped and printed, if the Automatic Reduction feature is disabled.
Options are to enable (YES) or disable (NO). The factory default is
NO.
Printer 1
Autoreduce Disabled (No)
Fig. 5.9 The Automatic Reduction Feature
The Maximum Width Menu
The Maximum Width menu, PRINT:MAXWIDTH, allows you to
set what the maximum width of jobs will be. You can choose any
size between 3' (.92 m) and 50' (15.25 m) in 1' (.31 m) increments
(or in 1 m increments if Units is set to METRIC). The factory
default is 5'.
When this setting is changed, the controller must be reset for the
change to take effect (either by power cycling the controller or by
using the Reset feature of Command Center). If a wider job than the
setting is sent to the controller, the job generates a configuration
error or reduces and prints if Automatic Reduction is set to YES.
5-18
Configurationbb
Printer 1
Autoreduce Enabled (Yes)
______________________________________