The Enable Menu
The Enable menu, PARALLEL:ENABLE, allows you to enable
(YES) or to disable (NO) the parallel interface on your controller.
The factory default is YES.
The Mode Menu
The Mode menu, PARALLEL:MODE, allows you to select the
PostScript mode. Options are PS STD, PS BIN, and PS TBCP. The
factory default is PS STD.
PS STD
PS BIN
PS TBCP
PostScript
The Buffer Menu
The Buffer menu, PARALLEL:BUFFER, allows you to reserve a
buffer area in the controller's RAM to hold incoming files. Options
are 8K, 16K, 32K, 64K, 128K, 256K, 512K, 1024K, 2048K, and
4096K. The factory default setting is 128K.
Note: This setting only takes effect if the controller is idle and
there is enough RAM available for the buffer.
The Spool Menu
The Spool menu, I/F:SPOOL, allows you to enable (YES) or disable
(NO) spooling to the parallel interface. The factory default is NO.
(See "Using the Spooler" in chapter 6 for more details.)
_______________________________________
for standard PostScript
for binary PostScript
for tagged binary communication protocol
Configuration 5-31