Recommended Printer Settings; The Main Menus - Xante Accel-a-Graphix CT4 User Manual

Recommended Printer Settings

We recommend that you review your printer documentation to
ensure that the settings will be acceptable for your application. For
example: The factory default setting for the ENCAD NOVAJET
printer is CUTTER: ON. This may cause ink to smudge if the
printout drops to the floor or desktop before ink is dry on the entire
image. We recommend that you change this setting on the ENCAD
to CUTTER: OFF and save that change in the USER SETTINGS as
SAVE USER 1. This sets the printer default to CUTTER: OFF.

The Main Menus

Your controller contains four main configuration menus (fig. 5.2):
the Print menu (SETUP:PRINT), the Job menu (SETUP:JOB), the
Miscellaneous (SETUP:MISC) menu, and the Interface (SETUP:I/F)
menu, which allow you to configure your controller through the front
panel.
SETUP: PRINT
PRINT: PRINTER1 JOB: ERASEALL
PRINT: PRINTER2 JOB: CLR TRP
PRINT: PRINTER3 JOB: PRINTER1
PRINT: PRINTER4 JOB: PRINTER2
PRINT: SCREEN JOB: PRINTER3
PRINT: CASCADE JOB: PRINTER4
PRINT: ACROSS
PRINT: BEST FIT
PRINT: ORIENT
PRINT: AUTOREDUCE
PRINT: MAXWIDTH
PRINT: SAVE MEDIA
PRINT: MARGINS
Fig. 5.2 The Main Configuration Menus
_______________________________________
ENTER
SETUP: JOB SETUP: MISC
MISC: UNITS
MISC: INITIAL JOB
MISC: TIMEOUT
MISC: LANG
MISC: RAMDISK
MISC: RASTERMODE
MISC: TEST
MENU
SETUP: I/F
I/F: RS232
I/F: PARALLEL
I/F: LTALK
I/F: ETALK
I/F: LPR
I/F: NVL PSRV
Configuration 5-9