Installing Ram Upgrades - Xante Accel-a-Graphix CT4 User Manual

Installing RAM Upgrades

After you access the controller board (fig. 2.4), you can install the
RAM upgrade(s).
To install RAM
Fig. 2.4 The Controller Board
Note: RAM banks must be filled in order from Bank 1 to Bank 4
and all banks must be full before you install a 32 MB SIMM.
If you mix 16 and 32 MB RAM SIMMs, the 32 MB SIMMs
must be installed in the lowest numbered SIMM banks
followed by 16 MB SIMMs. For example, if you have three
16 MB SIMMs and a 32 MB SIMM, install the 32 MB
SIMM in Bank 1 and the 16 MB SIMMs in Banks 2, 3, and
4. To install a second 32 MB SIMM, remove the 16 MB
SIMM from Bank 2 and replace it with the second 32 MB
SIMM.
1. Use your thumbs to pull open the two bank latches, one on
each end (fig. 2.5).
2-8 Installationbb _________________________________________
Bank 1 Bank 3
Bank 2 Bank 4