Configuring For Novell Pserver Operation - Xante Accel-a-Graphix CT4 User Manual

7. Press the Insert key and type in a queue name of your choice
for the New Print Queue Name.
8. Highlight the print server name that you typed in step 7.
9. Highlight QUEUE SERVERS and press the Enter key.
10. Press the Insert key and highlight the print server name that
you entered in step 4 (exactly as it was set using the XANTÉ
Command Utility).
11. Press the Escape key. You return to the Available Options
menu.
12. Turn your controller off and then on again.
Before the controller can advertise on the network (using the name
entered in step 4) in the Connection Information screen, you must
configure the controller for Novell Pserver Operation. The next
section covers that configuration.

Configuring for Novell Pserver Operation

Before the controller can advertise on the network, you must
configure it for Novell Pserver Operation using the two procedures
in this section.
First, use the following procedure to configuration through the
controller's front panel.
1. Press the Menu
2. Press the Enter
3. Press the Menu
4. Press the Enter
5. Press the Menu
6. Press the Enter
6-34 Routine Operationsbb
key until SETUP:I/F appears.
key.
key until I/F:NVL PSERV appears.
key.
key until NVL PSERV:ENABLE appears.
key.
__________________________________