Configuring For Novell Pserver Operation - Xante Accel-a-Graphix CT4 User Manual

9. Highlight Volume Object and press the Enter key.
10. Press the Enter key again.
11. Highlight the queue you designated in step and then press the
Enter key.
12. Highlight Print Servers and press the Enter key.
13. Press the Insert key and highlight your print server name that
you typed in step 4.
14. Press the Escape key. You return to the Available Options
Menu.
15. Turn your controller off and then on again.
Note: To view your queue and server setup, press F4 for bindery
mode.
Before the controller can advertise on the network (using the name
entered in step 4) in the Connection Information screen, you must
configure the controller for Novell Pserver Operation. The next
section covers that configuration.

Configuring for Novell Pserver Operation

Before the controller can advertise on the network, you must
configure it for Novell Pserver Operation using the two procedures
in this section.
Use the following first procedure to configuration through the
printer's front panel.
1. Press the Menu
2. Press the Enter
3. Press the Menu
4. Press the Enter
5. Press the Menu
___________________________________
key until SETUP:I/F appears.
key.
key until I/F:NVL PSERV appears.
key.
key until NVL PSERV:ENABLE appears.
Routine Operations 6-37