Setting The Controller As A Novell 3.X Queue Server - Xante Accel-a-Graphix CT4 User Manual

11. Click CONTROLLER.
12. Click and hold on NOVELL; then drag the pointer to the right.
13. Click PRINT SERVER LOGIN NAME. This name should be
the same as your Printer Server Name in PCONSOLE.
You can now use Novell's PCONSOLE to setup a printer queue. The
next section covers this setup for Novell network 3.x. If you have
version 4.x skip to "Setting the Controller as a Novell 4.x Queue
Server" later in this chapter.
Setting the Controller as a Novell 3.x Queue
Server
This section covers setting up your Accel-a-Graphix CT4 to run as a
queue server on a Novell network version 3.x. However, before you
do this, make sure the following statement is in the
AUTOEXEC.NCF on the Novell file server before proceeding to
PCONSOLE to set up the queue server.
Set allow unencrypted passwords = on
Note: You must have supervisory rights on the file server to set up
the Accel-a-Graphix CT4 as a queue server in PCONSOLE.
1. Login to the network.
2. Type PCONSOLE
3. Select Print Server Information from the Available Options
menu and press the Enter key.
4. Press the Insert key and type in the print server name exactly
as it was set using the XANTÉ Command Utility.
5. Press the Escape key. You return to the Available Options
menu.
6. Select Print Queue Information from the Available Options
menu and press the Enter key.
___________________________________ Routine Operations 6-33