Chapter 2. Server Components; Front View - Lenovo ThinkEdge SE360 V2 User Manual

Chapter 2. Server components

This section contains information about each of the components associated with the server.

Front view

This section contains information about the controls, LEDs, and connectors on the front of the server.
The front view of ThinkEdge SE360 V2 varies by model. Refer to the following information for front view
identification:
• "Front view with 1GbE I/O module" on page 19
• "Front view with 10/25GbE I/O module" on page 20
• "Front I/O fillers" on page 22
Note: All the connector numbers in this topic are listed from left to right.
Front view with 1GbE I/O module
Note: Depending on the model, your server might look slightly different from the illustration.
Figure 2. Front view with 1GbE I/O module
Table 3. Components on the front view with 1GbE I/O module
"Left wing of riser assembly" on page 20
1
"Right wing of riser assembly" on page 20
2
"Front operator panel" on page 21
3
"USB 3.2 Gen 1 (5 Gbps) Type-A connectors (USB 1
4
and 2)" on page 21
"USB 3.2 Gen 1 (5 Gbps) Type-C connector with
5
display support (USB 3)" on page 21
"USB 2.0 Type-C connector with Lenovo XClarity
6
Controller management (USB 4)" on page 21
© Copyright Lenovo 2023
"XCC system management port (1GbE RJ-45)" on page
7
21
"2.5GbE RJ-45 connectors (LAN 1 and 2)" on page 21
8
"1GbE RJ-45 connectors (LAN 3 to 6)" on page 21
9
LAN 6 with shared-NIC feature for Lenovo XClarity
Controller
"Bluetooth antenna or Bluetooth antenna filler" on page
10
21
For the models without wireless module, install the
Bluetooth antenna filler to the corresponding slot for proper
operation.
"XCC WLAN antennas" on page 22
11
"x86 WLAN antennas" on page 22
12
19