Table of Contents
Advertisement
After this task is completed
To reinstall the node to the wall, see
Install a node to the wall or the ceiling
Follow instructions in this section to install a node to the wall or the ceiling.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Reserve 500 mm of clearance in front of the node for installation/removal procedure.
• The maximal weight of the SE360 V2 node with node sleeve is 9.54 KG (21.03 lbs). For safe installation,
the wall to mount the node must be able to support 4 times of the weight, 38.16 KG (84.12 lbs). If not, the
surface must be reinforced to meet this standard.
• Avoid existing in-wall utilities, for example, plumbing, natural gas, or electrical input.
Important: This task must be operated by trained technicians.
Note: Depending on the model, your server might look slightly different from the illustration.
Procedure
Step 1.
The wall mount configuration requires four M4 screws and four M6 screws. Prepare screws and
related parts for this task.
Note: The appropriate length of the screw base should be assessed by qualified professionals.
ThinkEdge SE360 V2 User Guide
76
"Install a node to the wall or the ceiling" on page
and
"Safety inspection checklist" on page 48
54.
76.
to ensure that you
Advertisement
Table of Contents
Troubleshooting
