Table of Contents
Advertisement
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo Video
Watch the procedure on YouTube
Install the power module board (PMB)
Follow instructions in this section to install the power module board (PMB).
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1.
Make sure the signal cable between the front operator panel and rear operator panel is placed
outside the chassis.
ThinkEdge SE360 V2 User Guide
218
"Install the power module board (PMB)" on page
and
"Safety inspection checklist" on page 48
218.
to ensure that you
Advertisement
Table of Contents
Troubleshooting
