Table of Contents
Advertisement
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention: Power off the server and peripheral devices and disconnect the power cords and all external
cables. See
"Power off the server" on page
Procedure
Step 1.
Remove the node from the enclosure.
Note: Before removing the node from the enclosure, make sure to disconnect the grounding wires
from the grounding studs.
a.
Pull and hold the plungers on the enclosure bracket up to disengage the node from the
enclosure.
b.
Push the node out of the enclosure.
Figure 24. Removing the node
Note: A node bay should be installed with a node or a node filler. To install a node filler, insert the
filler into the node bay; then, secure the filler with two screws.
54.
Chapter 5
.
Hardware replacement procedures
57
Advertisement
Table of Contents
Troubleshooting
