Table of Contents
Advertisement
Figure 322. Removing the SMA filler
b.
For the model with wireless module, go to
Step 2.
Locate the cables of PMB side SMA assembly on the wireless adapter.
Step 3.
Disconnect the cables from the wireless adapter.
a.
Pinch and press the side of the cable holder; then, lift up one end of the cable holder from the
wireless adapter.
Figure 323. Lifting the cable holder
b.
Pivot the cable holder to
Step 2 on page 303
unlock position.
2
to remove the SMA assembly.
.
Chapter 5
Hardware replacement procedures
303
Advertisement
Table of Contents
Troubleshooting
