Table of Contents
Advertisement
Step 4.
Align the front of the riser assembly with the edge of the chassis; then, lower the riser assembly to
the node.
Figure 280. Lowering the riser assembly
Step 5.
Secure the riser assembly to the node.
a.
Tighten the three captive screws on the top of the riser assembly.
b.
Tighten the three screws on both sides of the node.
c.
Tighten the two thumbscrews in the front of the riser assembly.
.
Chapter 5
Hardware replacement procedures
261
Advertisement
Table of Contents
Troubleshooting
