Table of Contents
Advertisement
Figure 240. Removing the rear operator panel
Step 3.
Disconnect the cable from the rear operator panel.
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo Video
Watch the procedure on YouTube
Install the rear operator panel
Follow instructions in this section to install the rear operator panel.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
"Install the rear operator panel" on page
and
"Safety inspection checklist" on page 48
227.
.
Chapter 5
Hardware replacement procedures
to ensure that you
227
Advertisement
Table of Contents
Troubleshooting
