Lenovo ThinkEdge SE360 V2 User Manual page 292

<asset_tag>
[access_method]
Change the machine type for operating in an enclosure (trained technician only)
Use the following information to change the machine type for operating in an enclosure.
• "For a node to be installed into an enclosure" on page 282
• "For a node not to be reinstalled into an enclosure" on page 282
Important: This task must be operated by trained technicians.
Node to be installed into an enclosure
If the node is to be installed into a 2U2N Enclosure, change the machine type for proper operation.
To change the machine type for operating in a 2U2N Enclosure configuration, complete the following steps:
1. Enable IPMI on Lenovo XClarity Controller web interface or Lenovo XClarity Essentials OneCLI.
2. Implement the following IPMI commands:
ipmitool raw 0x3a 0x0c 0xE9 0x01 0x10 0x37 0x44 0x42 0x4E 0x43 0x54 0x4F 0x31 0x57 0x57
3. For data security purpose, make sure to disable IPMI again on Lenovo XClarity Controller web interface
or Lenovo XClarity Essentials OneCLI.
Node not to be reinstalled into an enclosure
If the node is removed from a 2U2N Enclosure and is not to be reinstalled to the 2U2N Enclosure, change the
machine type to the default mode for proper operation.
To change the machine type to the default mode, complete the following steps:
1. Enable IPMI on Lenovo XClarity Controller web interface or Lenovo XClarity Essentials OneCLI.
2. Implement the following IPMI commands:
ipmitool raw 0x3a 0x0c 0xE9 0x01 0x10 0x37 0x44 0x41 0x4D 0x43 0x54 0x4F 0x31 0x57 0x57
ThinkEdge SE360 V2 User Guide
282
The server asset tag number.
Type aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa, where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is
the asset tag number.
The access method that you select to access the target server.
• Online KCS (unauthenticated and user restricted):
You can directly delete [access_method] from the command.
• Online authenticated LAN:
In this case, specify below LAN account information at the end of the OneCLI
command:
--bmc-username <user_id> --bmc-password <password>
• Remote WAN/LAN:
In this case, specify below XCC account information and IP address at the end of the
OneCLI command:
--bmc <bmc_user_id>:<bmc_password>@<bmc_external_IP>
Notes:
– <bmc_user_id>
The BMC account name (1 of 12 accounts). The default value is USERID.
– <bmc_password>
The BMC account password (1 of 12 accounts).