Lenovo ThinkEdge SE360 V2 User Manual page 216

S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Remove the PMB air baffle. See
c. Lift the riser assembly from the node. See
228.
d. Remove the processor air baffle. See
board" on page
e. Remove Fan 2. See
f. Remove the rear dust filter. See
Note: If necessary, remove the rear operator panel for easier operation. See
operator panel" on page
Step 2. Disconnect the PMB status LED cable from the power module board; then, carefully remove the
cable from the cable clip.
ThinkEdge SE360 V2 User Guide
206
and "Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the processor air baffle and air flow sensor
110.
"Remove a fan module" on page
"Remove the rear dust filter" on page
226.
197.
"Remove the riser assembly from the node" on page
143.
to ensure that you
107.
97.
"Remove the rear