Lenovo ThinkEdge SE360 V2 User Manual page 182

Figure 177. I/O-board cable routing
I/O-board power cable I/O-board signal cable
1 2
After this task is completed
• Install a replacement unit. See "Install the I/O module board and M.2 boot drives" on page 172.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo Video
Watch the procedure on YouTube
Watch the procedure on YouTube
Install the I/O module board and M.2 boot drives
Follow instructions in this section to install the I/O board and M.2 boot drives.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
ThinkEdge SE360 V2 User Guide
172