Lenovo ThinkEdge SE360 V2 User Manual page 31

See "Slot and drive bay numbering" on page 31
assembly.
3 Front operator panel
See "Front operator panel LEDs" on page 373
4 USB 3.2 Gen 1 (5 Gbps) Type-A connectors (USB 1 and 2)
Connect a USB device, such as a mouse, keyboard, or other devices, to either of these connectors.
5 USB 3.2 Gen 1 (5 Gbps) Type-C connector with display support (USB 3)
Connect a USB device, such as a mouse, keyboard, monitor, or other devices, to either of this connector.
This connector supports display.
6 USB 2.0 Type-C connector with Lenovo XClarity Controller management (USB 4)
Connection to Lenovo XClarity Controller is primarily intended for users with a mobile device running the
Lenovo XClarity Controller mobile application. When a mobile device is connected to this USB port, an
Ethernet over USB connection is established between the mobile application running on the device and the
Lenovo XClarity Controller.
Only one mode is supported:
• BMC only mode
In this mode, the USB port is always solely connected to Lenovo XClarity Controller.
7 XCC system management port (1GbE RJ-45)
The server has a 1GbE RJ-45 connector dedicated to Lenovo XClarity Controller (XCC) functions. Through
the system management port, you can access the Lenovo XClarity Controller directly by connecting your
laptop to the management port using an Ethernet cable. Make sure that you modify the IP settings on the
laptop so that it is on the same network as the server default settings. A dedicated management network
provides additional security by physically separating the management network traffic from the production
network.
See the following for more information:
• "Set the network connection for the Lenovo XClarity Controller" on page 349
• "XCC system management port and LAN port LEDs" on page 380
8 9 LAN ports (LAN 1 to 6)
Connect an Ethernet cable to either of these connectors for LAN connection. See
port and LAN port LEDs" on page 380
LAN 6 supports shared-NIC feature for Lenovo XClarity Controller. This connector can be used both for
operating system networking and for remote management.
Note: The transmission speed of SFP28 connectors could be 10 Gbps or 25 Gbps, depending on the
processor selected. Processors with at least 16 cores support transmission speed of 25 Gbps.
Bluetooth antenna or Bluetooth antenna filler
10
Bluetooth antenna is an optional part, available for the models with wireless module. For the models without
wireless module, install the Bluetooth antenna filler for proper operation.
to identify the slot and drive bay numbering of riser
for more information.
for more information.
"XCC system management
.
Chapter 2 Server components
21