Replacement - Lenovo ThinkEdge SE360 V2 User Manual

Demo Video
Watch the procedure on YouTube
Power input board (PIB) module replacement
Follow instructions in this section to remove and install the power input board (PIB) module.
Remove the PIB module
Follow instructions in this section to remove the power input board (PIB) module.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Remove the PMB air baffle. See
c. Lift the riser assembly from the node. See
228.
d. Depending on the configuration, remove the power module board or internal power supply
unit. See "Remove the power module board (PMB)" on page 215
power supply unit (AC PMB)" on page
Step 2. Proceed to the section corresponding to the PIB module to be removed.
• "Remove the DC PIB module" on page 211
• "Remove the AC PIB module" on page 212
Remove the DC PIB module
Procedure
Step 1. Loosen the screw that secures the PIB module.
and "Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the riser assembly from the node" on page
151.
197.
107.
or "Remove the internal
.
Chapter 5 Hardware replacement procedures
to ensure that you
211