Lenovo ThinkEdge SE360 V2 User Manual page 192

After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo Video
Watch the procedure on YouTube
Install the lock position switch with cable
Follow instructions in this section to install the lock position switch with cable.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
Procedure
Step 1. Install the lock position switch with cable.
a. Route the cable through the hole on the chassis.
b. Fold the cable as shown; then, lower the lock position switch into the chassis, and push the
switch toward the chassis wall. Make sure that the screw hole on the bracket aligns with the
screw hole on the chassis.
c. Secure the lock position switch with one screw.
ThinkEdge SE360 V2 User Guide
182
"Install the lock position switch with cable" on page
and "Safety inspection checklist" on page 48
182.
to ensure that you