Table of Contents
Advertisement
Step 1.
Install the fan direction switch.
a.
Align the opening of the bracket with the guide pin on the chassis; then, insert the fan
direction switch at an angle until it stops.
b.
Rotate the fan direction switch as shown until the switch is firmly seated in the slot.
Figure 144. Installing intrusion switch with cable
Step 2.
Secure the fan direction switch with one screw.
Step 3.
Connect the fan direction switch cable to Air flow switch connector on the system board. See
"System-board connectors for cable routing" on page 327
Figure 145. Installing the fan direction switch
After this task is completed
Complete the parts replacement. See
Demo Video
ThinkEdge SE360 V2 User Guide
142
"Complete the parts replacement" on page
to locate the connector.
324.
Advertisement
Table of Contents
Troubleshooting
