Lenovo ThinkEdge SE360 V2 User Manual page 332

Figure 357. Locations of WLAN antennas
Note: The orientation of the following table aligns with the above illustration.
Antenna 1 (XCC WLAN)
1
Antenna 2 (XCC WLAN)
2
Step 2. Make sure the corresponding SMA assembly is installed properly. See
assemblies" on page
Step 3. Make sure the SMA connectors are fully extended. If necessary, turn the screw between the two
SMA connectors counterclockwise to extend the SMA connectors.
Important: When the SMA connectors are fully extended as shown in the following illustration,
STOP turning the screw counterclockwise. Turning the screw excessively might cause damage to
the components.
Figure 358. Extending the SMA connectors
ThinkEdge SE360 V2 User Guide
322
311.
Antenna 4 (x86 WLAN)
4
Antenna 3 (x86 WLAN)
3
"Install the SMA