Din Rail Configuration - Lenovo ThinkEdge SE360 V2 User Manual

Step 12. Connect the power cable and other necessary external cables to the node.
Step 13. Power on the server and any peripheral devices. See
Step 14. (Optional) If necessary, install the security bezel.
Note: When the security bezel is installed, the front operator panel and USB Type-C connectors
are not accessible.
a. Insert the tab of security bezel into the slot; then, pivot the security bezel toward the node
sleeve until the other side of security bezel clicks into place.
Note: Make sure that the external cables in front of the node go through the corresponding
openings of the security bezel.
b. Lock the security bezel with the key, and store the key for future use.
Figure 69. Installing the security bezel

DIN rail configuration

Follow instructions in this section to remove and install the DIN rail configuration.
Remove a node from the DIN rail
Follow instructions in this section to remove a node from the DIN rail.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Reserve 500 mm of clearance in front of the node for installation/removal procedure.
Note: Depending on the model, your server might look slightly different from the illustration.
Procedure
Step 1. If applicable, remove the security bezel.
ThinkEdge SE360 V2 User Guide
84
"Power on the server" on page
and "Safety inspection checklist" on page 48
53.
to ensure that you