Chapter 6. Internal Cable Routing; Identifying Connectors; System-Board Connectors For Cable Routing - Lenovo ThinkEdge SE360 V2 User Manual

Chapter 6. Internal cable routing

See this section to do cable routing for specific components.
Note: Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from
the system board. Failing to release them before removing the cables will damage the cable sockets on the
system board, which are fragile. Any damage to the cable sockets might require replacing the system board.

Identifying connectors

See this section to locate and identify the connectors on the electric boards.

System-board connectors for cable routing

The following illustrations show the internal connectors on the system board that are used for internal cable
routing.
Figure 361. System-board connectors
Table 18. System-board connectors
Air flow switch connector
1
Intrusion switch connector
2
Fan 1 connector
3
Air flow sensor board connector
4
Fan 2 connector
5
© Copyright Lenovo 2023
PCIe Gen 4 MCIO 2 connector
8
M.2 cabled adapter / PCIe cabled riser card power
9
connector
GPU power connector
10
M.2 cabled adapter power connector
11
I/O module board signal connector
12
327