Slot 2 / M.2 Bay 1
1
Slot 1 / M.2 Bay 0
2
Step 2.
Remove the M.2 drive.
a.
Loosen the screw that secures the M.2 drive.
b.
Pivot the rear side of the M.2 drive away from the M.2 adapter.
c.
Remove the M.2 drive from the slot.
Note: If necessary, repeat this procedure to the other M.2 drive to be removed.
Figure 174. Removing an M.2 drive
Remove the I/O module board
Procedure
Step 1.
Disconnect all the cables from the I/O module board. While disconnecting the cables, make a list of
each cable and record the connectors the cable is connected to, and use the record as a cabling
checklist after installing the new I/O module board.
Step 2.
Loosen the six screws that secure the I/O module board.
Step 3.
Lift the I/O module board to remove it.
.
Chapter 5
Hardware replacement procedures
169