Table of Contents
Advertisement
Step 1.
If a drive filler is installed in the drive bay, remove it first. Keep the drive filler in a safe place for
future use.
a.
Slide the release latch to unlock the handle.
b.
The handle opens automatically.
c.
Grasp and pull the handle to remove the drive filler from the drive bay.
Figure 98. Removing a drive filler
Step 2.
Install the 7mm drive.
a.
Slide the drive into the drive bay, and push it until it stops.
b.
Rotate the handle back to the locked position.
Figure 99. Installing a 7mm drive
Step 3.
(Optional) If any of the drive bays is left empty, fill it with a drive filler.
a.
Slide the drive filler into the drive bay, and push it until it stops.
b.
Rotate the handle back to the locked position.
.
Chapter 5
Hardware replacement procedures
103
Advertisement
Table of Contents
Troubleshooting
