Lenovo ThinkEdge SE360 V2 User Manual page 17

Storage controller
Software RAID
• Intel VROC SATA RAID: supports RAID level 0, 1
• Intel VROC NVMe RAID
– VROC Standard: supports RAID level 0, 1, 10 and requires an activation key.
– VROC Premium: supports RAID level 0, 1, 5, 10 and requires an activation key.
Notes:
• Mixing storage drives and boot drives in one RAID array is not supported.
• Up to four storage drives are supported to be in one RAID array.
Notes: The storage drives in the following groups are supported to configure in one RAID array with drives of the
same group. Drives in different groups cannot be in the same RAID array.
– M.2 storage drives on the left wing of riser assembly (Slot 3 to 6)
– M.2 storage drives on the right wing of riser assembly (Slot 7 to 10)
– 7mm storage drives (Bay 0, 1) and M.2 storage drives on the bottom M.2 cabled adapter (Slot 11, 12)
• For more information about RAID configuration, see
• For more information about acquiring and installing the activation key, see
System fan
• Two 80 mm x 80 mm x 56 mm dual-rotor fans, supporting one of the following air flow directions:
– Front-to-rear air flow direction
– Rear-to-front air flow direction (supporting dust filter measurement feature)
Notes:
– With air flow sensor board installed, SE360 V2 BMC supports dust filter measurement feature to check the
status of the rear dust filter. See
– Specific mounting options of SE360 V2 require specific fan air flow direction. See
page 54 for more information.
RAID configuration.
"Set dust filter measurement" on page 364
https://fod.lenovo.com/lkms
for more information.
"Configuration guide" on
.
Chapter 1
.
Introduction
7