Table of Contents
Advertisement
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Note: Make sure you have the drive bay fillers available if some drive bays will be left empty after the
removal.
Procedure
Step 1.
Loosen the captive screw that secures the bezel; then, remove the bezel.
Figure 96. Removing the bezel
Step 2.
Remove the 7mm drive.
a.
Slide the release latch to unlock the drive handle.
b.
The handle opens automatically.
c.
Grasp and pull the handle to remove the drive from the drive bay.
Figure 97. Removing a 7mm drive
.
Chapter 5
Hardware replacement procedures
101
Advertisement
Table of Contents
Troubleshooting
